OzzieTraveller
14-09-2010, 2:33pm
G'day all
It seems to me that every day I'm off walking around with one of the cameras slung over my shoulder, that I am constantly pulling the damn thing back onto my shoulder - as it tries to slide off and go its own way
Over the years, I have tried a number of options to stop the "slip slidin' away" with varying degrees of success, but now I seem to have found one that works... using domestic non-slip material glued to the inner face of the camera strap :)
Stuff needed
a) a strip of non-slip material, about 2cm wide x (from 30cm up to) the length of your camera strap
b) a soft drink bottle (to wrap the strap around)
c) a tube of contact adhesive
Here goes...
1- the inner face of the basic camera strap - woven webbing material
http://i56.tinypic.com/mjljef.jpg
2- wrap the non-slip material around a soft-drink bottle. (Stickytape ends onto bottle to stop it unwinding)
http://i54.tinypic.com/2ceg7c7.jpg
3- use some contact-adhesive
http://i54.tinypic.com/2dahhs0.jpg
4- wrap the camera strap around the now-glued non-slip material** ps: leave for 24hours to dry completely
http://i54.tinypic.com/246t8hi.jpg
5- the completed camera strap with the non-slip material in place
http://i56.tinypic.com/vcw7wg.jpg
** by wrapping the strap around a bottle, it helps stop the crinkling one gets after gluing two things lying flat, when they are later used with a bend in them
Hope this helps other Apers
Regards, Phil
It seems to me that every day I'm off walking around with one of the cameras slung over my shoulder, that I am constantly pulling the damn thing back onto my shoulder - as it tries to slide off and go its own way
Over the years, I have tried a number of options to stop the "slip slidin' away" with varying degrees of success, but now I seem to have found one that works... using domestic non-slip material glued to the inner face of the camera strap :)
Stuff needed
a) a strip of non-slip material, about 2cm wide x (from 30cm up to) the length of your camera strap
b) a soft drink bottle (to wrap the strap around)
c) a tube of contact adhesive
Here goes...
1- the inner face of the basic camera strap - woven webbing material
http://i56.tinypic.com/mjljef.jpg
2- wrap the non-slip material around a soft-drink bottle. (Stickytape ends onto bottle to stop it unwinding)
http://i54.tinypic.com/2ceg7c7.jpg
3- use some contact-adhesive
http://i54.tinypic.com/2dahhs0.jpg
4- wrap the camera strap around the now-glued non-slip material** ps: leave for 24hours to dry completely
http://i54.tinypic.com/246t8hi.jpg
5- the completed camera strap with the non-slip material in place
http://i56.tinypic.com/vcw7wg.jpg
** by wrapping the strap around a bottle, it helps stop the crinkling one gets after gluing two things lying flat, when they are later used with a bend in them
Hope this helps other Apers
Regards, Phil