View Full Version : Flash Compensation/Output question .. ??
bigdazzler
11-02-2009, 12:20pm
Setup is this ..
1 x off camera speedlight. Triggered in wireless mode from the onboard camera flash.
My question is, by setting the onboard flash comp. to negative and therefore reducing the amount of direct light emitted onto the subject, will this affect the output of the speedlight or will it remain at full power ??
Thankyou :D
Bunyip
11-02-2009, 12:53pm
I know that in the Nikon world, using the Nikon CLS mode, the answer would be Yes. I don't know if it's the same in the Sony world. I suppose that it would be possible to determine by taking a couple of shots with and without compensation, and checking the resultant exposure.
Not to sure what the menus on Canons/Sonys are like - but on the Nikons you can set the on board commander flash and the slave flash at seperate values. Setting the on board flash to commander mode (--) and the slave flash (SB800 in this case) to a specified power. You can also select FEC separately for each flash from this menu.
Maybe someone can translate this into Sony-ese?
Did you end up deciding on a trigger set up yet? :)
bigdazzler
11-02-2009, 5:48pm
Unfortunately my camera doesnt have a onboard flash commander mode. Would be a simple solution if it did. :rolleyes:
In the last few days Ive gotten all my adapter bits and have just ordered a set of cheapie triggers to play around with. I ordered the Phottix PT-04s from fleebay for $35. Im not expecting too much from them but for peanuts ill give them a try.
If the turn out to be just too unreliable Ill probably end up springing for a couple of Pocket Wizards ..
So i'm guessing that means your flash works as a simple slave mode - similar to the old Nikon SU-4 commander mode - where the slave is tripped by the on board flash but there is no communication between the two? ie - the slave flash setting must be set on the flash itself?
If this is the case then your best bet until you get the triggers is to set the on board flash to its lowest manual power (1/128th on my D90, not sure what options the A300 has) so as to provide minimum contribution to the exposure while still tripping the slave.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.