ameerat42
12-08-2019, 8:18am
I have to (try to) get data off a WD My Book 250 GB external drive. It's attached via USB 2.
After connect and switch on, it takes about 1~2 mins to display anything at all, as shown below.
So far all I've tried is a different USB cable (as if expecting a miracle:rolleyes:) with no change,
and HardDiskSentinel reported that it's "99% OK".
For my next trick I will remove it from the case and connect it via a dock. I expect it'll be SATA
and that it has a USB-SATA board inside (at worst, IDE, but still OK).
I suppose I'm expecting "something wrong with this board" which the removal of "will fix". :confused013
Anything else I can consider? (Yes, it's garbage night here tonight :D)
What a Naughty Drive looks like. (I'm told it's about "half-full")...
140854
- - - Updated - - -
PS: File Manager says...
Location is not available.
X E:\ is not accessible.
Access is denied.
(Do you think there's a message there somewhere :confused013)
After connect and switch on, it takes about 1~2 mins to display anything at all, as shown below.
So far all I've tried is a different USB cable (as if expecting a miracle:rolleyes:) with no change,
and HardDiskSentinel reported that it's "99% OK".
For my next trick I will remove it from the case and connect it via a dock. I expect it'll be SATA
and that it has a USB-SATA board inside (at worst, IDE, but still OK).
I suppose I'm expecting "something wrong with this board" which the removal of "will fix". :confused013
Anything else I can consider? (Yes, it's garbage night here tonight :D)
What a Naughty Drive looks like. (I'm told it's about "half-full")...
140854
- - - Updated - - -
PS: File Manager says...
Location is not available.
X E:\ is not accessible.
Access is denied.
(Do you think there's a message there somewhere :confused013)